Basting
Sew a running stitch through the labeled dots.
1Pierce A0 on top
Pierce A0 on the top piece from its unprinted side. The loose thread stays behind the needle eye.
2Pierce A0 on the bottom
Continue through A0 on the bottom piece, from its printed side. Do not pull the thread tight yet.
3Pull A0 together
Pull the needle through until the starter knot meets the top A0. Bring only the two A0 points together; leave the rest of the pieces apart.
4Return through A1 on the bottom
From below, poke the needle tip through A1 on the bottom piece. The thread still runs from A0 to the needle eye.
5Return through A1 on top
Continue upward through A1 on the top piece. Pull the needle eye and thread through both pieces.
6Pull A1 snug
Pull the thread taut to remove any slack, but stop before the fabric puckers. This is your first stitch, visible from the bottom of your piece stack.
7Stitch through A2
Your next stitch will be visible from the top.
More help
Your next stitch will be visible from the top. Pierce the top piece from the unprinted side through the third labeled dot, and then the bottom piece from the printed side through the matching dot. Pull the stitch taut.
8Keep alternating
Repeat this process, alternating between making a stitch visible from the bottom and top.
9Finish at the last dot
When you have reached the final labeled dot of the seam, you will sometimes see that the final labeled dot is much closer to the previous dot, and may only have 1 or 2 unlabeled dots between them.
More help
When you have reached the final labeled dot of the seam, you will sometimes see that the final labeled dot is much closer to the previous dot, and may only have 1 or 2 unlabeled dots between them. If this is the case, your final stitch will just be short.
Preparation guides
1Thread a needle
Unwind a comfortable arm-length of red basting thread from the metal bobbin.
Open full guide →Photo guide ↗2Tie a starter knot
Tips
1Tips 1
Use the red basting thread on the metal bobbin, doubled through your needle. Remove these long temporary stitches after sewing the permanent seam.
2Tips 2
With opaque fabric you cannot see through the layers, so piercing one at a time will let you make sure the dots are lined up.