End knot (basting)
Create a backstitch, make a knot around it, and trim your thread.
1Go back one small dot
From the opposite side to your last basting stitch, go back one small dot—not a whole labeled interval. This short backstitch crosses the blank space on that side.
2Return to the end
On the original side, stitch forward to the final dot again, overlapping the last basting stitch.
3Pull snug
Pull taut. On the opposite side, you should now see a short stitch spanning one small-dot interval.
4Slide the eye underneath
On the opposite side, lead with the eye of the needle and slide it under the short backstitch without piercing the fabric.
5Leave a small loop
Pull your threaded needle until you see a loop the size of your thumb form. Stop well before the loop gets small and disappears.
6Pass through the loop
Bring your threaded needle around the other side of the loop and put it through the loop
7Tighten the knot
Pull the needle past the final dot, continuing along the seam line, until the knot tightens.
8Check for slack
Gently pull the pieces apart to check the seam.
More help
Gently pull the pieces apart to check the seam. Only tiny crosswise rungs should show; wide, visible rungs mean too much slack. The long stitches stay hidden inside the allowance folds.
9Trim the tails
Bring the seam allowances back together, then trim both thread tails close to the knot.
Tips
1Tips 1
Keep the loop small so the knot sits tight to the corner.